Job openings & fellowships Job openings
Select Page
Caption: left: STEM imaging of crystal where the red and green balls represent bismuth and sulphur atoms. Right: schematic illustration of Bi2S3 detector on the Si/SiO2 substrate
Caption: left: STEM imaging of crystal where the red and green balls represent bismuth and sulphur atoms. Right: schematic illustration of Bi2S3 detector on the Si/SiO2 substrate

Defects enable RoHS-compliant, high-performance infrared photodetectors

A study led by ICFO researchers reports on a highly sensitive CMOS compatible broadband photodetector by tailoring material defects.

April 02, 2019
There has been an urgent need in consumer electronics for infrared optoelectronics including light emitting diodes and photodetectors. To date, however, infrared optoelectronics are served by costly CMOS incompatible III-V semiconductors. Recently a new class of semiconductors that address the CMOS compatibility issue has emerged based on colloidal quantum dots. When it comes to consumer electronics the use of RoHS compliant materials is a prerequisite and therefore there is a strong need for the development of high performance devices based on environmentally friendly elements, something that in the infrared had remained elusive.

To address this challenge ICFO researchers have discovered that by controlling defects in materials one can extend the semiconductor’s spectral reach beyond its bandgap, expanding thereby the material availability for the infrared part of spectrum.

In a recent study published in Advanced Optical Materials, ICFO researchers Dr. Nengjie Huo, Dr. Alberto Figueroba, Dr. Y. Yang, Dr. Sotirios Christodoulou, Dr. Alexandros Stavrinadis, led by ICREA Prof at ICFO Gerasimos Konstantatos, in collaboration with Prof. C. Magén from Univ. of Zaragoza, have reported on the development of an infrared detector using Bismuth Sulphide, which has proven to have fast and high photo-response levels in the short-wave infrared range thanks to the formation of defects in the material. In their experiment, the team of researchers fabricated a photoconductive detector, depositing a very thin layer of Bi2S3 flakes onto a Si/SiO2 substrate. Once built, the team was able to observe that the Bi2S3 flakes possessed sulphur vacancies or defects in the material (sulphur-deficient), which created extended in-gap states, which allowed an increased absorption of light below the bandgap value of Bi2S3, that is sub-bandgap. Such features led to a high gain, low noise and, subsequently, a high sensitivity photodetector.

To shed insights in the sulphur deficiency mechanism, they built a second photodetector and synthesized the Bi2S3 crystal, by performing a sulfurization process (changing the concentration percentages of Bi and S in the crystal) and subsequently refilling the sulphur vacancies. In doing this, they were able to observe that the photodetector had a much faster response time but was limited to the spectral range in the near infrared. Thus, to improve the response time without sacrificing its spectral coverage into the infrared, they carried out a mild chemical treatment on the sulphur-deficient-based detector, through a surface passivation process of the crystal. Completing the treatment, they observed that the time response had reached a value of approximately 10ms for the infrared and visible light range, 50 times faster than the original sulphur deficient-based detector.

The results of this study provide new insights into the role atomic vacancies play in the electronic structure and how sub-bandgap photoresponse effects can enable ultrasensitive, fast, and broadband photodetectors.

This work has been partially supported by the European Commission’s Graphene Flagship initiative.